











Novelio® wall covering Classic EasyPaint (pre-painted)
Novelio® Classic EasyPaint fiberglass wall coverings require just one layer of paint to ensure durable protection, offering an application time saving of 30%.
Pre-painted wall coverings
For those looking for fast wall renovation without compromising on durability, Novelio® Classic EasyPaint pre-painted wall coverings require just one layer of paint to ensure durable protection, offering an application time saving of up to 30%.
The decorative range comes pre-painted for an easier application, but still provides a superior level of protection to walls and ceilings for impact resistance. What's more, the painted wall covering is ideal for crack prevention and crack covering for wall renovation.
When it comes to cost and time savings, Novelio® Classic EasyPaint impact resistant wallcovering can save one day of paint drying time - which equates to 30% of working time - and a material saving of six litres of paint for a 15 m² room.
- Prepainted for an easier application
- Crack prevention and abrasion resistance
- Crack covering for wall renovation
- Time saving: 1 day of paint drying time - 30% of working time
- Material saving: 6 litres of paint for a 15 m² room
- Durable protection of the wall with only 1 layer of acrylic paint
- Easily washable and re-paintable
Vlies
Ceiling
Braid
Weaving
Fishbone
Small Fishbone
Crepi
Metis
Technical Data Sheet (10)
Declaration of performance (1)
Certification (2)
How should the wall coverings be applied on internal and external corners?
Novelio wall coverings have a specially designed coating that ensures trouble-free folding and bending around internal and extenal corners.
At least 20cm of material should extend past the corner on each side to ensure proper adhesion.
What method should I use to join the edges of the wall coverings?
All ADFORS Novelio fiberglass wall coverings feature precisely cut edges and are designed to be applied edge to edge.
Pay close attention to the edges of the roll, as any damage to them will make the seam more visible.
For non-woven textiles (vlies), you can perform a double-cut to make the joints invisible.
How should the wall coverings be installed in humid environments?
Humidity has no effect on the installation of the fiberglass wall coverings. You just need to ensure that the proper glue is used for application in humid environments.
Please keep in mind that Novelio wall coverings should not come into direct contact with water (e.g. from a shower), unless this is something specifically designed within the system.
How can I remove excess glue from the wall coverings?
Use a wet towel or sponge to remove the glue as soon as possible after application. This is key, as the glossiness of the wall covering's surface will be negatively affected if the glue is allowed to dry.
How much glue should be applied on the wall coverings?
The optimal amount of glue is around 250g per m2. A good test for checking if you have the right amount of glue is is to see if you can draw in the glue with your finger.
It's important to spread the glue evenly on the fiberglass wall covering and make sure the layer has a uniform thickness. Remember that it's always better to have too much glue than not enough.